SARV COAT 8571

Epoxy VinyL hich bulid primer COATINGS

Description

Sarv coat 8571 is a two component, vinyl polyamida cured epoxy primer.

Physical Data

Finish............................................... Flat

Colour............................................. Upon request

Volume Solids............................... 44±2%

Specific Gravity............................ 1.15 ±0.05 gr/cm³

Flash Point..................................... 23°C

Recommended D.F.T................... 70-80 microns

Theoretical coverage.................... 6.28-5.5 sqm/lit

                                                          5.46-4.78 sqm/kg

Practical Coverage....................... depends on loss factor

Touch dry....................................... Max 2 hrs at 20°C

Fully cured..................................... 7  days at 20°C

Thermal Resistance...................... 140°C

Shelf life......................................... 1 year at 25°C

Package.......................................... 5& 20 liter container

Application Details

Application method .................... Air/Airless spray, Brush

Nozzle orifice................................. . .021"

Nozzle pressure............................. 150 bar/2200 Psi

Application temperature............. 5-50°C

Mixing ratio................................... 4/1 by weight

Thinner/Cleaner............................ SVT-85

Pot life ............................................ 8 hrs at 20°C

Recoat interval.............................. Min 24 hrs

                                                           Max 4 months

Outstanding Characteristics

• Good UV resistance
• Excellent chemical resistance against weak acids and alkalis.
• Suitable as finish coat in various paint systems.
• Corrosion resistance in moderately to severely environment.

Recommended Use

As a protective intermediate coat in industrial and marine structures, over concrete or metal surfaces.

Surface Preparation

Remove oil and grease, etc. with suitable detergent. Remove salt and other contaminants by (high pressure) fresh water cleaning. Clean damaged area thoroughly by power tool cleaning to ST3 (minor aress)

Or by abrasive blasting to minimum SA2, Preferably to SA2 ½ (for repair and maintenance) abrasive blasting to SA 2 ½ SSPC-10 (for new steel)